Work Complete - Chopping Bad

So after several month of work done during the evening and in the week-end, I,ve finally complete my prject.
I hope that you like it. Any comments will be appreciated.

Control

From Chemichal Candy Custom

Michael Schmidt Photography

taken form Iron and Air, here is the link Michael Schmidt Photography

Moto Guzzi GSX21

Even if I'm an adept of Harley church this really makes me thinking that also the new Guzzi start to be interesting....

Mass Ride of 1 november -Snors for a cause

On 1st of November, for Movember action Pretoria chapter organized a mass ride. It was impressive, a little bit boring but, really massive! 230 bikes were there.
Here below some picture...

Breakfast Run - Bronkhorstspruit

Finally after a long time...on the road again

Work in progress

after the chain tensioner I've also modified the carter, made some holes and then cutted the outside portion.

Raw result installed

Finishined and installed together with the chain tensioner

Work in progress

this is how it looks the chain tensione installed just to take the measurements. need to be convered with another plate and finalized. Look ate the previous post for the history.

After I've welded 2 plate to create the space for the nut

Then I've built the cover plate and made holes 

This is the raw result installed

Welding

After finishing butt weld on horizontal position now I'm working on vertical position..next week piping 45 degrees. Then it's done!

Springer Systers

And here we go! my new bilke in the garage with her syster..